Wantec 2wIP TX adapter (receiver) TCP/IP network over 2-wire, 1-Port, screw terminals, Ethernet/PoE output (4722)

2wIP E-Series 2-Wire Ethernet Adapter with PoE - Screw Terminals - Client / Receiver - 1-Port
With the Wantec 2wIP a network connection can be established via a 2-wire line. PoE is also transmitted, so PoE devices (e.g. IP camera, SIP phone, IP door phone,...) can be operated without additional power supply. The 2wIP E-Series provides a bandwidth of up to 200Mbit/s on 2-wire or coax lines.

Depending on the version, the transmitters can be powered via PoE or with the included power supply. The PoE function can be switched off at the receiver of the 2wIP E-series.

SKU	0180
Category	Accessories (Assembly, Extension, Licenses)
Manufacturers

179,90 € (Net 151,18 €)

incl. 19% VAT , plus

Available immediately
Delivery time: 2 - 3 Workdays (DE - int. shipments may differ)

2wIP E-Series TX Adapter (Receiver) with one Ethernet/PoE output (Ethernet/PoE over 2-wire)

Connection: terminal block / pluggable screw terminals

Product Code 5722

Cable length up to 1500m with coax, 600m with twisted pair or bell wire
Transmission speed up to 200MBit/s per link
Multiport, a 1-port transmitter can control up to 4 receivers, the 4-port transmitter unit can control up to 8 receivers
PoE with up to 38 Watt per receiver
PoE function can be switched off at the receiver unit
No programming required for basic configuration, plug and play, plug in, run
Of course, also works with SIP phones, access points, etc.

Connection setup:

2-establish wire connection between transmitter and receiver, connect in bus system, observe polarity.
Plug the end device into the 2wIP receiver.
Connect the 2wIP transmitter to the network switch by means of a patch cable.
(in case of transmitter for power supply via PoE, a PoE switch or PoE injector is required).
If a transmitter with power supply via the enclosed power supply unit is used:
Connect the power supply to the 2wIP transmitter, then insert the power plug into the power outlet.
Finished, the transmitters and receivers configure themselves.

Technical data

At least 2 adapters (1 RX transmitter + 1 TX receiver) are required for operation

General technical data

Ethernet connector RJ45
Speed 10/100 Base T, half/full duplex, auto-negotiation
IEEE 802.3 af/at Compliant PoE
Coax connector BNC, RG-59/U or similar
Impedance 50 to 100 Ohm
Maximum cable length up to 1500m
Encryption: 128-bit AES
Topology: star, ring or daisy-chain as well as mixed
Power Output: max. 25,4Watt
Recommended temperature range -10 to +50 C° (14°F to 122°F)

Package Content

Wantec 2wIP device
EU Power supply unit (only for transmitter units for power supply via power supply unit)
Instruction manual
For devices with BNC connection, 1 adapter to 2-wire connection is included for each BNC connection